akvapark írta: ↑2019.06.25., kedd 17:11
Klaca írta: ↑2019.06.25., kedd 15:54
...
Egy rega kar esetében számít az valamit, hogy a
vtf beállítót 0 ra állítva csak az ellensúly tologatásával állítom be a
vtf-et (tűmérleggel), vagy pedig kiegyensúlyozom a kart, és utána a beállítót csavargatom addig, amíg jó nem lesz a tűnyomás.
...
"A VTF az mást jelent; szerintem a vertikális szöghibát.)
Az RB 300-as nál volt egy olyan gondolat, hogy az ellensúly állító rugót nullára - egyesek szerint meg maximumra - kell állítani, és csak az ellensúllyal kell a tűerőt beállítani.
Az RB300 kar manual-ja (pl.
http://www.tonlaget.com/pdf/rb300.pdf) szerint:
"
Cartridge tracking force adjustment
1. Ensure that the tracking force adjustment knob is set to the zero position.
2. With the cartridge permanently fitted in the correct position adjust the main balance weight so that the arm is “floating” with the stylus just 1mm clear of a record.
(This adjustment should be made with the anti-skating knob to zero. Note: Even
at zero there will be some small residual anti-skating force. Therefore it may also
be necessary to gently touch the arm bearing carrier to stop the arm moving outwards).
3. Rotate the tracking force adjustment knob to the required tracking force. If in
doubt it is usually advisable to use a tracking force that corresponds with the
upper limits of the cartridge manufacturer’s range."
Nem értem, miért szeretnék egyesek máshogy csinálni, mint ahogy a gyártó ajánlja...
Most sem tudom kihagyni nagy kedvencem, az utolsó bekezdés címét: "Further adjustments for the neurotic/paranoid enthusiast"
VTF; helyes, vagy nem helyes, erről szerintem magyar nyelvterületről felesleges vitatkozni, általánosan használatos, pl.:
https://www.vinylengine.com/library/rega/rb300.shtml
"VTF is applied by a dial on the side of the vertical pivot housing."
https://www.vinylengine.com/turntable_f ... hp?t=31691
"What VTF can cause damage to records?"